PTC Thermistors from Thermik
(motor protection sensors, resistors, PTC sensors ...)

Thermik has much experience as one of the few manufacturers of PTC ceramics. As the basic technology is of great significance in manufacturing, our thermistors and PTC motor protection sensors are of much higher quality than standard products.

PTC Motor Protection Sensors and Thermistors available:

SNM SKM STM LTM

 

 

Installation

The PTC‘s are usually installed parallel to the coil so that the mechanical strain is minimized. The Mylar-Nomex shrink cap is well suited due to its mechanical stability (no cold flow, as opposed to Tefl on). In conjunction with the miniature pill (Ø 1,5 mm), response times of ≤ 5 seconds to a maximum of 10 seconds were achieved.

Function

Thermik thermistors correspond to DIN 4408, DIN 44082 and IEC 34-11-2, and exhibit a very high temperature sensitivity. The resistance increases strongly in the area of the rated response temperature. This change can be used to switch off the load circuit through a triggering device. Electronic evaluations of many different applications are also possible. The typical characteristics of Thermik thermistors are presented in the temperature resistance diagram.

Advantages:

  • Small dimensions
  • Fast response times
  • Mechanical stability
  • Temperature-resistance-characteristic-curves individually made for the application

Resistance Diagram

Temperature Resistance Diagram and Primary Parameters as per DIN 44081 / 44082 and IEC 34-11-2

Customer Specific Designs

Design K – customer specific – upon request Possible Variations/Additions:

  • Colour coding
  • Wire insulation material or wire cross-section
  • Cable end packing
  • Connection technology
  • UL wire components used
  • High voltage proof insulation (suited for safety class II applications)

Application field of PTC Motor Protection Sensors / Thermistors

Application field of PTC Motor Protection Sensors / Thermistors
Application field of PTC Motor Protection Sensors / Thermistors